Calibre

Seagull ST1901

A column wheel you can afford

Seagull · Modern ST19 family; historical predecessor ST3

Open the interactive schematic

Overview

Sea-Gull describes the ST19 as an optimized development of the ST3 aviation chronograph, whose Project 304 development began in 1961. That predecessor and the modern ST1901 are distinct revisions, rather than one unchanged movement in continuous production since 1963. The current manufacturer page specifies manual winding, 22 jewels and 21,600 vibrations per hour. Its reserve is approximately 37 hours with the chronograph operating and 45 hours without it.

Represented revision: Modern ST1901 specification on Sea-Gull’s manufacturer page; older variants differ

Recorded specifications

Origin
Modern development of ST3 / Project 304 aviation chronograph
Jewels
22
Frequency
21,600 vph (3 Hz)
Power reserve
≈ 37 hours chronograph running / 45 hours stopped
Diameter
28.0 mm
Winding
Manual
Control
Column wheel
Clutch
Lateral (horizontal)
Counters
30-minute (single register)

Models and relatives

Facts and references

These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.

About the illustration

The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.

Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.

Compare this calibre in the library