Calibre

Longines L990

Two barrels under a central rotor

Longines · 1977 – 1994

Open the interactive schematic

Overview

Longines introduced the 2.95 mm L990 in 1977. Its construction combines two barrels with a conventional central rotor and a unidirectional automatic winding system. Centre seconds are indirect: the train drives a separate central-seconds pinion held steady by a friction spring. Those relationships, including both barrels, are shown here as functional groups based on Longines’ service manual; the diagram does not reproduce its numbered factory disassembly sequence.

Represented revision: L990.1/.2 architecture in reproduced factory service instructions

Recorded specifications

Barrels
Two, small and large
Display
Indirect centre seconds and date
Jewels
25
Frequency
28,800 vph (4 Hz)
Power reserve
≈ 45 hours
Diameter
≈ 27.0 mm (approximate)
Height
2.95 mm
Winding
Automatic, central rotor, unidirectional
Made
Entirely at Saint-Imier
Note
Released in 1977, in the middle of the quartz crisis

Models and relatives

Facts and references

These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.

About the illustration

The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.

Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.

Compare this calibre in the library