A. Lange & Söhne L951.1
The Datograph
A. Lange & Söhne · Original Datograph generation (introduced 1999; discontinued)
Overview
Widely held to be the most beautifully made chronograph movement of the modern era, and unusual in that the case back is the point: Lange finish the side nobody needs to see. Column wheel, flyback, and an outsize date driven by two discs behind one aperture rather than a single ring — which is the only way to get numerals that large into a movement this size. The plates are German silver, left unplated so they tone with age; the balance cock is engraved by hand, so no two are identical; and the whole movement is assembled twice, taken apart after the first time so the finished parts can be cleaned of any mark the fitting left.
Represented revision: L951.1 in original Datograph403.035; distinct from Up/Down L951.6
Recorded specifications
- Components
- ≈ 405
- Jewels
- 40, four in screwed gold chatons
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 36 hours
- Diameter
- 30.6 mm
- Height
- 7.5 mm
- Winding
- Manual
- Chronograph
- Column wheel, flyback, lateral clutch
- Calendar
- Outsize date, two discs
- Plates
- Untreated German silver
Models and relatives
- A. Lange & Söhne Datograph 403.035, original L951.1
- Datograph Up/Down uses the distinct L951.6
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Lange Datograph 403.035 official archive
Scope: L951.1; 405 parts; manual winding; 36 hours; 18,000 vph; outsize date and chronograph; model no longer in current collection. The drawing remains schematic; other claims are not established by this reference.
- Lange Datograph technical text reproduced by MasterHorologer
Scope: Reproduced technical block gives 30.6 mm diameter and 7.5 mm height. The introductory old component count conflicts with the later official 405-part archive and is not adopted.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.