A. Lange & Söhne Zeitwerk L043.1
It reads like a clock, not a watch
A. Lange & Söhne · 2009 – present
Overview
A watch that shows the time as three numerals in a row instead of two hands, and jumps every one of them at the top of the minute. The problem with that is energy: flicking a disc round takes a sudden pull that the mainspring cannot supply without the balance feeling it, and the minute discs are heavy. Lange's answer is a constant-force remontoir that sits between the barrel and the escapement, rewound once every sixty seconds and paced by a fly governor. The escapement never sees the mainspring at all — it sees a small spring that is topped up every minute — so it gets the same torque on hour thirty-five as on hour one, and the numerals jump on someone else's energy.
Represented revision: L043.1 in2020 catalogue,68-jewel iteration
Recorded specifications
- Height
- 9.3 mm (2020 catalogue specification)
- Jewels
- 68 (2020 catalogue specification)
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 36 hours
- Diameter
- ≈ 33.6 mm
- Winding
- Manual
- Display
- Jumping hour/minute numerals, small seconds and power-reserve hand
- Constant force
- Remontoir rewound every 60 seconds
- Indication
- Power reserve
Models and relatives
- A. Lange & Söhne Zeitwerk, from 2009
- the base of the Zeitwerk Striking Time and Minute Repeater
- German silver plates, hand-engraved balance cock
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Lange 2020 official catalogue (indexed page 45)
Scope: Indexed catalogue page 45: 415 parts; 68 jewels; 33.6 mm diameter; 9.3 mm height; 36 hours; manual winding; constant-force mechanism; jumping numerals; subsidiary seconds and power-reserve hand. The drawing remains schematic; other claims are not established by this reference.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.