La Joux-Perret G100
Three hands, date and 68 hours
La Joux-Perret · Current catalogue; introduction not established
Overview
La Joux-Perret’s G100 is a 4 Hz automatic with a published 68-hour reserve, unidirectional self-winding and stop seconds. The factory drawing shows a date at 3 o’clock and a separate correction position. The maker states dimensional compatibility with ETA 2824 and SW200; this does not establish parts interchangeability. The visible family arrangement is drawn from factory imagery. Hidden trains, dial-side geometry and the on-screen strip/rebuild order are explanatory, not factory service documentation.
Represented revision: Current manufacturer catalogue G100 with date; visible family bridgework from the linked G100 finish sheet; hidden mechanisms remain schematic groups
Recorded specifications
- Maker
- Manufacture La Joux-Perret
- Jewels
- 24
- Frequency
- 28,800 vph (4 Hz)
- Power reserve
- 68 hours
- Diameter
- 25.6 mm
- Height
- 4.45 mm
- Casing diameter
- 26 mm
- Winding
- Automatic, unidirectional
- Hand-winding
- Yes
- Hacking
- Yes
- Display
- Hours, minutes, centre seconds and date
- Crown positions
- 3: winding, date correction, time setting
- Compatibility
- ETA 2824 / SW200 dimensional only; parts interchangeability not established
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- La Joux-Perret G100 — manufacturer specification
Scope: Own-calibre functions, 24 jewels, 4 Hz, 68 hours, unidirectional winding, stop seconds, movement/casing dimensions and dimensional compatibility; not a parts or service guide
- La Joux-Perret G100 — factory crown-control drawing
Scope: Central hours/minutes/seconds and crown winding; date at 3 and three crown positions including date correction
- La Joux-Perret G100 family — factory finish sheet linked from G100
Scope: Visible family arrangement, central three-screw rotor hub, broad upper bridgework, separate balance cock and decoration variants; the sheet is labelled G100 even on the G101 page and does not establish hidden G101 internals
- La Joux-Perret — factory rear photograph linked from G100
Scope: Visible central rotor hub with three screws, balance/cock and index regulator; photograph orientation differs from the finish sheet; not an exploded view
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.