Chronomatic Calibre 11
Crown on the left, for a reason
Heuer / Breitling · 1969 – 1970s
Overview
The 1969 collaboration combined a Buren micro-rotor base with the Dubois Dépraz 8510 chronograph module over its bridge side. The module uses cam switching and an oscillating-pinion coupling. The crown is on the left, opposite the pushers. These two assemblies are shown as functional groups. The original 6.69 parts sheet names a wig-wag pinion, stop click and winding/reduction gears in the Buren automatic train; those parts are grouped rather than replaced with a generic reversing-wheel pair. Exact internal meshes and lever positions remain schematic.
Represented revision: Original 1969 Chronomatic 11; not the modern TAG Heuer namesake
Recorded specifications
- Base
- Buren micro-rotor automatic
- Chronograph
- Cam-controlled Dubois Dépraz 8510 module, bridge side
- Jewels
- 17
- Frequency
- 19,800 vph (2.75 Hz)
- Power reserve
- ≈ 42 hours
- Diameter
- 31.0 mm
- Winding
- Micro-rotor automatic; direction not established by the inspected parts sheet
- Crown
- Left-hand side
- Counters
- 30-minute, 12-hour
- Note
- Dimensions approximate
Models and relatives
- Heuer Monaco 1133 — the Steve McQueen watch
- Heuer Autavia and Carrera
- Breitling Chrono-Matic
- Hamilton Chrono-Matic
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Heuer 11 original parts sheet, 6.69
Scope: Original 6.69 inventory: automatic stop click 1428, winding wheel 1480, reduction gear 1481, ratchet drive 1482, wig-wag pinion 1500 and coupling wheel 1521; oscillating pinion 8086 and hammer-cam parts. The list does not establish winding direction, surveyed positions or a service procedure
- Heuer 11 parts inventory
Scope: Hammer cam, oscillating-pinion coupling and 8510 module parts
- TAG Heuer original Chronomatic history, 2024
Scope: 1969 Buren micro-rotor/Dubois-Depraz collaboration and left-crown history; detailed coordinates remain schematic
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.