Grand Seiko 9SA5
A new escapement, in 2020
Grand Seiko · 2020 – present
Overview
Very few makers have ever put a genuinely new escapement into production. Grand Seiko did it in 2020 with the Dual Impulse: the escape wheel pushes the balance directly in one direction and through the lever in the other, which cuts the sliding friction of a conventional Swiss lever without going to the complexity of a co-axial. Add twin barrels side by side for eighty hours at 5 Hz, a free-sprung balance with an overcoil, and a horizontal bridge layout that let them make it thinner than the movement it replaced.
Represented revision: 9SA5 in Grand Seiko combined9SA4/9SA5/9SC5 instructions
Recorded specifications
- Normal-use accuracy
- −1 / +8 s per day target (manufacturer instructions)
- Jewels
- 47
- Frequency
- 36,000 vph (5 Hz)
- Power reserve
- ≈ 80 hours
- Diameter
- 31.6 mm
- Escapement
- Dual Impulse — direct and via the lever
- Barrels
- Two, side by side
- Balance
- Free-sprung, overcoil hairspring
- Accuracy
- −3 / +5 s per day: uncased laboratory mean daily rate
- Note
- The escapement here is drawn schematically
Models and relatives
- Grand Seiko Hi-Beat SLGH series
- the 9SA5 replaced the long-running 9S85
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Grand Seiko 9SA5 overcoil and free-sprung balance
Scope: The exact 9SA5 page identifies its separately developed overcoil and four-screw free-sprung regulation. The generic terminal arc does not reproduce its factory spring profile, dimensions or adjustment.
- Grand Seiko 9SA5 movement specifications
Scope: 9SA5 date; automatic and manual winding; 47 jewels; 36,000 vph; approximately 80 hours; −3/+5 seconds daily rate is an uncased laboratory mean; normal-use target is −1/+8 seconds per day. The drawing remains schematic; other claims are not established by this reference.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.