Chopard L.U.C 96.01-L
A micro-rotor over two stacked barrels
Chopard · 1996 – present
Overview
Chopard was a jewellery house that decided, in the mid-1990s, to become a movement manufacturer, and the 96 is the movement it built to prove it. Two things define it. The micro-rotor sinks the winding weight into the plate instead of stacking it on top, so the calibre is 3.3 mm thick. And the two barrels are not side by side, as almost everyone else does it, but stacked on the same arbor — Chopard calls it Twin technology — which buys sixty-five hours without buying the width. It is finished to Geneva Seal standard, including the parts nobody sees.
Represented revision: 96.01-L in XPS1860Officer161242-0001
Recorded specifications
- Balance spring
- Phillips terminal curve
- Balance wheel
- Three spokes
- Jewels
- 29
- Frequency
- 28,800 vph (4 Hz)
- Power reserve
- ≈ 65 hours
- Diameter
- ≈ 27.4 mm
- Height
- ≈ 3.3 mm
- Winding
- Automatic, micro-rotor
- Barrels
- Two, stacked on one arbor
- Finishing
- Poinçon de Genève on many references
Models and relatives
- Chopard L.U.C XPS 1860 Officer, reference 161242-0001
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Chopard L.U.C official general instruction manual
Scope: PDF page 56 identifies XPS 1860 reference family 161242 with 96.01-L and three arms/Phillips overcoil; its case execution is not the exact Officer 161242-0001. PDF page 53 assigns the listed Quattro references to 98.01-L/98.09-L with four barrels. Neither table establishes this Officer balance's regulating hardware.
- Chopard XPS 1860 Officer 161242-0001 official specification
Scope: 29 jewels; 208 parts; 3.30 mm; 4 Hz; 65 hours; two stacked coaxial barrels; 22K gold microrotor; Phillips terminal curve; three-spoke balance; date/small seconds. The drawing remains schematic; other claims are not established by this reference.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.