Rolex Calibre 9001
Sky-Dweller — the annual calendar
Rolex · 2012 – 2023
Overview
The 2012 Sky-Dweller combines an annual calendar with dual time. Its calendar distinguishes a thirty-day month from a thirty-one and only wants correcting once a year, at the end of February. The Saros system adds four gear wheels and two gear ratios to the instantaneous date calendar. Rolex patented the arrangement as Saros after the astronomical cycle. On top of that sits a second time zone read against a rotating disc under the hour markers, and the whole thing is set through the bezel — turn it to choose whether the crown moves the date, the local hour or the reference time.
Represented revision: Original 9001 Sky-Dweller; calendar/interface shown as grouped functions
Recorded specifications
- Components
- ≈ 380
- Patents
- Seven for9001; fourteen for the whole watch (2012 release)
- Jewels
- 40
- Frequency
- 28,800 vph (4 Hz)
- Power reserve
- ≈ 72 hours
- Diameter
- ≈ 33.0 mm (approximate)
- Calendar
- Annual — Saros adds four gear wheels to the date calendar
- Complication
- Annual calendar, second time zone
- Correction
- Once a year, at the end of February
- Balance
- Free-sprung, Microstella nuts
- Hairspring
- Blue Parachrom, Breguet overcoil
Models and relatives
- Rolex Sky-Dweller 326935, the inspected 9001 brochure execution
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Rolex official Saros description
Scope: Four added gear wheels and two gear ratios, not four total calendar parts
- Rolex Sky-Dweller2012 launch press kit (reproduced original)
Scope: Pages1–9: seven patents for 9001 versus14 for the whole watch,380 parts, month display, independent local hour, reference disc and Ring Command selector.
- Rolex 9001 Sky-Dweller326935 brochure
Scope: 9001 functions, off-centre reference disc, month apertures, stop seconds,72-hour reserve and Paraflex; not9002 internal architecture.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.