Valjoux 72
The pre-Daytona chronograph
Valjoux · 1938 – 1974
Overview
If a vintage chronograph matters to collectors, the odds are good this is inside it. Rolex used it in every Daytona from 1963 until 1988, rebadged as the 722 and later the 727. Heuer put it in the Carrera and the Autavia. Breitling, Gallet and Universal all used it. Manual wind, column wheel, lateral clutch, three registers — the same architecture as the Omega 321 and a direct ancestor of everything in this set that switches on a column wheel.
Represented revision: Standard time-and-chronograph Valjoux 72; not calendar 72c or moon-phase 88
Recorded specifications
- Jewels
- 17
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 40 hours
- Diameter
- 29.5 mm (13 ligne)
- Winding
- Manual
- Control
- Column wheel
- Clutch
- Lateral (horizontal)
- Counters
- 30-minute, 12-hour, small seconds
- Rebadged as
- Rolex 722, 722-1, 727
Models and relatives
- Rolex Daytona 6239, 6241, 6262, 6263, 6265 (as cal. 722 / 727)
- Heuer Carrera and Autavia
- Breitling, Gallet, Universal Genève
- the definitive mid-century Swiss chronograph
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Valjoux technical communication for 72/72c/88/90
Scope: Separate hour-recorder work and distinction from calendar 72c / moon-phase 88; geometry not established by converted text
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.