Omega 684
An automatic, in seventeen and a half millimetres
Omega · 1971 – 1989
Overview
This compact automatic was made for smaller watches. A movement cannot simply be scaled down: halve a balance and you take away far more than half its inertia, so it is disturbed by knocks a larger one shrugs off, and a smaller barrel holds a shorter mainspring however thin the steel is drawn. Omega put a rotor on top of that anyway, and a sweep seconds hand and a date as well, inside seventeen and a half millimetres. The seconds hand is the part worth stopping on, because it is not driven by the train directly. The wheel that turns once a minute sits off to one side and carries no hand at all; instead the third wheel drives a slim pinion that runs up through the hollow centre wheel to the middle of the dial. Omega did this on almost everything it made, and the reason is space — uncoupling the seconds from the train lets the balance sit right out at the rim, which on a plate this size is the difference between fitting and not fitting. The price is one extra mesh with backlash in it, so a flat spring presses on the pinion to hold it steady. When a vintage Omega's seconds hand shuffles and jumps instead of sweeping, that spring is almost always the reason.
Represented revision: 684 version A; dimensions and reserve from Omega TG-19-C-119-FDES A cover (2013)
Recorded specifications
- Jewels
- 24
- Frequency
- 21,600 vph (3 Hz)
- Power reserve
- 45 hours (2013 factory guide)
- Diameter
- 17.50 mm (18.0 mm overall, 7.98 lignes)
- Height
- 4.30 mm (2013 factory guide)
- Winding
- Automatic, central rotor
- Calendar
- Date, semi-quickset by moving the hands past midnight
- Display
- Indirect centre seconds and date
- Shock protection
- Incabloc
- Made
- 1971–1989; 1,500,000 across the 683, 684 and 685 together
Models and relatives
- ladies' Omega De Ville, Genève and Seamaster of the 1970s and 80s
- the flagship of Omega's small calibres
- shares many parts with the hand-wound 620 family
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Omega TG-19-C-119-FDES A cover, October 2013
Scope: 2013 version A cover: 4.30 mm high, 45 h, 24 jewels, 3 Hz and 18.00 mm diameter; full geometry not established
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.