Omega 565
The 1960s Seamaster engine
Omega · 1966 – 1969
Overview
The last and best of the 5xx family, and the movement in an enormous number of Seamasters and Constellations. A full rotor at last, running on a bearing rather than bouncing off buffers, with a date advanced by an additional outward pull of the crown, returning it between advances. It is the direct ancestor of the 1010 family that replaced it, and the two together cover Omega's automatic output from 1955 to 1980. Look at how the seconds hand is driven: not by a wheel of the train sitting in the middle of the movement, but by a slim pinion at the centre that the third wheel turns through a mesh of its own, with a flat spring pressing on it to take up the play. Omega used that arrangement almost everywhere — the same friction spring, part 1255, fits every calibre from the 550 to the 752 and the little 684 as well — and it is the reason a tired Omega shows its age first in a seconds hand that stutters.
Represented revision: 563/564/565 pull-crown quickset architecture
Recorded specifications
- Jewels
- 24
- Frequency
- 19,800 vph (2.75 Hz)
- Power reserve
- 50 hours
- Diameter
- 27.9 mm mounting (28.4 mm overall)
- Height
- 5.05 mm
- Winding
- Automatic, bidirectional
- Calendar
- Date, quickset by an additional outward crown pull
- Display
- Indirect centre seconds and date
- Family
- Omega 55x / 56x calibres
- Successor
- The 1010 family, from 1972
Models and relatives
- Omega Seamaster and Constellation of the late 1960s
- the 564 is the same movement certified as a chronometer
- succeeded by the 1010 family in 1972
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Omega 563/564/565 factory calendar guide, 1966
Scope: Pull-crown date correction and corrector/yoke linkage
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.