Hamilton 500
The first watch with a battery in it
Hamilton · 1957 – 1961
Overview
Announced in January 1957 and the first battery-powered wristwatch ever sold. There is no mainspring or barrel. The balance carries a coil; a stationary contact spring meets a tab on the moving balance, closing the circuit once per full oscillation. The coil receives an electrical impulse in the field of fixed magnets. A roller jewel on the balance advances a fifteen-tooth index wheel, held in position by an index magnet. The wheel advances on alternate vibrations, and from there it is a reduction gear train. It was a genuine landmark and it was not a good watch: the contacts fouled, the pulse faltered and Hamilton spent four years revising it before replacing it with the 505. Every electronic watch since starts here.
Represented revision: Hamilton Model 500; factory 500/501 service-guide architecture
Recorded specifications
- Type
- Electric — battery, coil and mechanical contacts
- Frequency
- 18,000 vph (2.5 Hz)
- Jewels
- 12
- Power
- 1.5 V energy cell; original guide specifies yearly replacement
- Contacts
- 9,000 operations per hour (2.5 Hz)
- Indexing
- 15-tooth wheel, roller jewel and index magnet
- Diameter
- ≈ 25.6 mm (approximate)
- Escapement
- Electrically impulsed balance with magnetic indexing
- Introduced
- January 1957
- Note
- The first battery-powered wristwatch
Models and relatives
- Hamilton Ventura, 1957 — the asymmetric case
- Hamilton Van Horn and other Electric models
- superseded by the 505, and by transistors soon after
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Hamilton Electric factory service manual
Scope: 1.5 V cell, alternate-vibration electrical contact, moving coil, 15-tooth magnetic indexing; reproduced factory guide
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.