Landeron 48
The chronograph everyone could afford
Landeron · 1940s – 1960s
Overview
For every Valjoux 72 there were a great many of these. Landeron switched its chronograph with a cam instead of a column wheel, decades before the 7750 made that respectable, and built them in the millions. Collectors were sniffy about it for years and the market has largely come round: the cam does the same job, it is easier to service, and a Landeron 48 in good order runs as well as anything. Two registers only — thirty minutes and running seconds.
Represented revision: Landeron 48 standard 30-minute execution; 1953 guide also lists distinct 45-minute parts
Recorded specifications
- Jewels
- 17
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 41 hours
- Diameter
- 31.00 mm
- Winding
- Manual
- Control
- Switching cam
- Clutch
- Lateral (horizontal)
- Counters
- 30-minute (no hour counter)
- Note
- Dimensions approximate; the family spans several sizes
Models and relatives
- an enormous number of mid-century chronographs
- the standard movement for affordable Swiss chronographs of the period
- the direct ancestor of the cam-switched approach in the 7750
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Le Landeron 48 Ebauches technical communication, March 1953
Scope: Original 1953 cover and parts: 31 mm, no column wheel, separate 30/45-minute recorder executions
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.