Rolex Calibre 4161
Yacht-Master II — a programmable countdown
Rolex · 2013 generation; distinct from 4160 and 4162
Overview
A regatta starts on a countdown, and a skipper needs to be on the line at zero rather than approaching it. This movement counts down from any figure between one and ten minutes, remembers that figure through a reset, and can be synchronised on the fly to the official race countdown. The exact pusher operation follows the instructions for this generation. Programmable mechanical memory is a strange thing to find in a wristwatch, and it is why this runs to some three hundred and sixty components. The bezel is part of the mechanism, not the case: turning it unlocks the programming.
Represented revision: 4161 Yacht-Master II116680,2013 launch execution; not4160 or4162
Recorded specifications
- Components
- ≈ 360
- Jewels
- 42
- Frequency
- 28,800 vph (4 Hz)
- Power reserve
- ≈ 72 hours
- Diameter
- ≈ 33.0 mm (approximate)
- Complication
- Programmable countdown, 1–10 minutes
- Memory
- Mechanical — survives a reset
- Sync
- On-the-fly countdown synchronisation
- Control
- Column wheel, vertical clutch
Models and relatives
- Rolex Yacht-Master II 116680,2013 generation
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Rolex Yacht-Master II e-brochure (reproduced original)
Scope: 4161 identity,360 components, programmable1–10-minute memory, on-the-fly synchronisation and bezel interface.
- Rolex 2013 technical specification reproduced by MasterHorologer
Scope: Reproduced manufacturer specification:42 jewels,4 Hz,72 hours, column wheel/vertical clutch, running small seconds at 6 and stop seconds. Not a factory disassembly guide.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.