Calibre

Rolex Calibre 4030

The Daytona that was a Zenith

Rolex · 1988 – 2000

Open the interactive schematic

Overview

For twelve years the Daytona ran on somebody else's movement. Rolex had no automatic chronograph of their own, bought the Zenith El Primero, and then changed roughly half of it: the frequency came down from 36,000 to 28,800, the escapement was replaced with a Rolex one and a Breguet overcoil hairspring, the date work was removed, and the balance was made free-sprung with Microstella nuts. The parts reference confirms the 4 Hz execution; it does not establish a universal wear-versus-frequency rule or the engineering reason for that choice. Compare the distinct regulator and display execution with the El Primero400 rather than assuming parts interchangeability.

Represented revision: Zenith-based 4030, 1988–2000

Recorded specifications

Base
Zenith El Primero 400, heavily modified
Jewels
31
Frequency
28,800 vph (4 Hz) — reduced from 36,000
Power reserve
≈ 54 hours
Diameter
≈ 30.5 mm (approximate)
Control
Column wheel
Clutch
Lateral (horizontal)
Balance
Free-sprung, Microstella nuts
Hairspring
Breguet overcoil

Models and relatives

Facts and references

These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.

About the illustration

The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.

Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.

Compare this calibre in the library