Omega 342
The one that bumps
Omega · 1949 – 1952
Overview
The 342 uses a winding weight whose travel is limited by sprung buffers. A wrist movement can make the weight strike a buffer, giving the characteristic bumper feel. Only one direction of swing transmits winding. This was one automatic architecture in use during the period, alongside full-rotation systems; the drawing shows its principle schematically.
Represented revision: 342 / 28.10 RA PC T1 AM, 17-jewel execution in Omega GF 620-1 (1954)
Recorded specifications
- Jewels
- 17
- Frequency
- 19,800 vph (2.75 Hz)
- Power reserve
- ≈ 42 hours
- Diameter
- 28.10 mm
- Height
- 4.80 mm
- Winding
- Bumper automatic, unidirectional
- Rotor arc
- About 270 degrees, buffered at each end
- Family
- Omega 3xx bumper calibres
- Successor
- The 5xx full-rotor family
Models and relatives
- Omega Seamaster and Centenary of the 1940s and early 1950s
- the 3xx bumper family: 330, 332, 342, 344, 351, 354
- replaced by the full-rotor 5xx family from 1955
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Omega bumper winding technical discussion, AWCI
Scope: Unidirectional limited-rotation winding
- Omega GF 620-1 calibre 342, 1954
Scope: 1954 original sheet: 17 jewels, 28.10 mm, 4.80 mm, 19,800 A/h and bumper-weight components
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.