Longines 30CH
The 13ZN grown up
Longines · 1947 – 1970s
Overview
The 30CH followed the 13ZN as Longines’ wrist-chronograph movement. Longines’ archive identifies a 1965 reference 7413 as a flyback chronograph, dates the 30CH family to 1947 and describes its semi-instantaneous 30-minute counter and fifth-second reading. The original parts sheet identifies 18 jewels, 18,000 vibrations per hour and small seconds. This illustration follows that 30-minute function set; it does not establish a complete inventory of every historical version.
Represented revision: 30CH with30-minute register;1965 Longines7413 archive example
Recorded specifications
- Counters
- Semi-instantaneous 30-minute register and small seconds
- Jewels
- 18
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 44 hours
- Diameter
- 29.80 mm (13¼ ligne)
- Height
- 6.20 mm
- Winding
- Manual
- Control
- Column wheel
- Clutch
- Lateral (horizontal)
- Predecessor
- The Longines 13ZN
Models and relatives
- Longines Flyback-Chronograph 30CH, reference 7413, 1965 archive example
- 30-minute counter function set; individual historical versions require matching documents
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Longines Flyback-Chronograph 30CH 1965 archive
Scope: 30CH origin in 1947; semi-instantaneous 30-minute counter; fifth-second reading; selected archive example identified as flyback. The drawing remains schematic; other claims are not established by this reference.
- Longines 30CH original parts sheet reproduced by Cousins UK
Scope: First sheet visually checked: 13¼ ligne, 29.80 mm diameter, 6.20 mm height, 18 jewels, 18,000 vph, small seconds and 30-minute register. The numbered parts drawings do not establish the schematic coordinates or a service order.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.