Omega 2500
The first co-axial in production
Omega · 1999 – 2012
Overview
Omega put George Daniels' co-axial escapement into series production in 1999 in the 2892-derived 2500 family. The versions must be distinguished: A and B run at 4 Hz; C and D run at 3.5 Hz. The D execution represented here has a three-level co-axial wheel rather than the earlier two-level arrangement. Reduced sliding friction does not mean the production escapement runs dry: Omega specifies its lubrication in the matching technical documents.
Represented revision: 2500D: later 25,200 vph, three-level co-axial execution
Recorded specifications
- Base
- ETA 2892-A2-derived; 2500D represented
- Jewels
- 27
- Frequency
- 25,200 vph (3.5 Hz)
- Power reserve
- ≈ 48 hours
- Diameter
- 25.6 mm (11½ ligne)
- Height
- 4.10 mm (2500D technical guide)
- Escapement
- Three-level co-axial (2500D only)
- Inventor
- George Daniels, produced from 1999
- Successor
- The in-house 8500 and 8900
Models and relatives
- Omega Seamaster, Aqua Terra, De Ville from 1999
- base: ETA 2892-A2, escapement by George Daniels
- superseded by the in-house 8500 family from 2007
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Omega calibre 2500D technical guide
Scope: Factory comparison of A/B/C/D rate and escapement revisions; D execution represented
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.