Vacheron Constantin Calibre 2260
Fourteen days, on a Maltese cross
Vacheron Constantin · 2012 – present
Overview
A tourbillon does not tell you anything a plain watch does not. It exists because a balance running in a vertical position gains or loses depending on which vertical position it is in, and if you turn the whole escapement slowly through all of them, those errors average out instead of accumulating. Breguet patented the idea in 1801 for pocket watches, which sit in one position all day; on a wrist it is far more argued about. What is not arguable is the difficulty. The carriage has to carry the balance, the pallet fork and the escape wheel, be poised to a fraction of a milligram, and weigh almost nothing, because the going train pays for every turn it makes. Vacheron then asked it to run for fourteen days off four barrels, and shaped the carriage bar as the Maltese cross of the house emblem.
Represented revision: 2260 in Patrimony Traditionnelle89000/000R-9655, 2011 launch release
Recorded specifications
- Display
- Hours, minutes, small seconds on tourbillon and power reserve
- Components
- ≈ 231
- Jewels
- 31
- Frequency
- 18,000 vph (2.5 Hz)
- Power reserve
- ≈ 14 days (336 hours)
- Diameter
- 29.10 mm
- Height
- 6.80 mm
- Winding
- Manual
- Barrels
- Four, in two coupled pairs
- Tourbillon
- One rotation per minute, Maltese-cross carriage
- Certification
- Poinçon de Genève
Models and relatives
- Vacheron Constantin Traditionnelle 14-Day Tourbillon
- Traditionnelle Tourbillon Collection Excellence Platine
- stamped with the Poinçon de Genève — the Hallmark of Geneva
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Vacheron 2260 launch text, reproduced by La Cote des Montres
Scope: 29.10 mm diameter; 6.80 mm height; 31 jewels; 231 parts; 18,000 vph; four barrels coupled in pairs all unwinding simultaneously; 336 hours; small seconds on tourbillon; power-reserve display. The drawing remains schematic; other claims are not established by this reference.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.