Calibre

Bulova Accutron 214

It hums instead of ticking

Bulova · 1960 – 1977

Open the interactive schematic

Overview

An early electronic wristwatch with no balance or conventional escapement. Its coil circuit sustains a steel tuning fork at 360 cycles a second, and an index finger pushes a wheel 2.4 mm across with three hundred teeth round, one tooth per cycle. That is the whole idea: vibration turned directly into rotation, with nothing that locks and unlocks. It ran to about a minute a month when a good mechanical watch managed a minute a week. Quartz eventually displaced tuning-fork watches in the mass market, although the mechanical train of a quartz movement can still require servicing.

Represented revision: Bulova 214; factory service-manual architecture

Recorded specifications

Type
Electromechanical, tuning fork
Oscillator
360 Hz steel tuning fork
Jewels
12
Accuracy
About a minute a month
Battery
Original 1.35 V cell; modern substitution needs specialist assessment
Diameter
Not established in the cited factory material
Setting
From the back — no case-side crown
Escapement
None

Models and relatives

Facts and references

These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.

About the illustration

The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.

Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.

Compare this calibre in the library