Calibre

Omega Calibre 1861

The long-serving Moonwatch

Omega · 1996 – 2021

Open the interactive schematic

Overview

The 321's eventual replacement, and the calibre that actually spent most of the Speedmaster's life in production. The visible difference is how the chronograph is switched: instead of a column wheel there is a shaped cam. It controls start, stop and reset through its levers. The architecture is a manual-wind, lateral-clutch chronograph, with a rhodium-plated finish.

Represented revision: 1861A, as described in the Omega factory technical guide

Recorded specifications

Base
Lemania 1873
Components
≈ 240
Jewels
18
Frequency
21,600 vph (3 Hz)
Power reserve
≈ 48 hours
Diameter
27.0 mm
Height
6.87 mm (1861A factory guide)
Winding
Manual
Control
Switching cam
Clutch
Lateral (horizontal)
Balance
Regulator index

Models and relatives

Facts and references

These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.

About the illustration

The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.

Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.

Compare this calibre in the library