Vacheron Constantin Calibre 1731
Strikes the time on demand
Vacheron Constantin · 2013 – present
Overview
A minute repeater chimes the time when you ask it to: low notes for the hours, a double note for each quarter, high notes for the minutes since. It was invented for the dark, before you could strike a light to read a dial, and it survives because it is the hardest thing in watchmaking to do well. The mechanism is not told the time — it measures it. Racks fall onto snails turning with the hour wheel and the cannon pinion, and how far each rack drops is how many teeth it presents to the hammers. Everything after that is acoustics: the gongs, how they are anchored, how the case is built, and a governor that has to pace the strike without being heard doing it. This one is 3.90 mm thick, which for a repeater is the difficult part twice over.
Represented revision: 1731 in Patrimony30110/000R-9793, 2013 introduction
Recorded specifications
- Components
- ≈ 265
- Jewels
- 36
- Frequency
- 21,600 vph (3 Hz)
- Power reserve
- ≈ 65 hours
- Diameter
- 32.80 mm
- Height
- 3.90 mm
- Display
- Hours, minutes and small seconds at 8
- Winding
- Manual
- Striking
- Hours, quarters and minutes on two gongs
- Governor
- Centrifugal, silent-running
- Certification
- Poinçon de Genève
Models and relatives
- Vacheron Constantin Patrimony ultra-thin minute repeater 30110/000R-9793
- Calibre 1731, introduced in 2013
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Richemont 2014 annual-results presentation
Scope: Manufacturer presentation image establishes subsidiary seconds; snail profiles here are functional schematics, not factory geometry.
- Vacheron 1731 launch text, reproduced by WatchMobile7
Scope: 32.80 mm diameter; 3.90 mm height; 36 jewels; 265 parts; 65 hours; 21,600 vph/3 Hz; small seconds8; minute repeater. The drawing remains schematic; other claims are not established by this reference.
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.