Omega 1012
Inside the TV-dial Seamaster
Omega · 1972 – 1984
Overview
Omega's automatic date workhorse through the 1970s, and the movement behind the decade's strangest-looking Seamasters — the TV-screen and cushion cases that everyone either loves or cannot forgive. It replaced the 55x/56x family and carried the range until quartz took the volume away. The thing to look at is how it winds. Almost every Swiss automatic of the period takes the rotor's motion through a pair of reversing wheels; the 101x family instead uses a wig-wag pinion, a single wheel that slides along an oblong slot in the barrel bridge, held by a screw acted on by a separate spring. It drives while engaged and slides clear in the opposite direction. It has a fraction of the parts a reversing train needs, and the whole automatic module lies flat on the plate rather than stacking on top of it, which is why the movement is only 4.25 mm thick. Solid, serviceable and unglamorous, which by the standards of what a 1970s watch usually contains is high praise.
Represented revision: 1012, 1972 factory technical guide; seconds train remains schematic
Recorded specifications
- Family
- Omega 1010 – 1022
- Jewels
- 23
- Frequency
- 28,800 vph (4 Hz)
- Power reserve
- 48 hours minimum, per the Omega technical guide
- Diameter
- 27.90 mm
- Height
- 4.25 mm
- Lift angle
- 52 degrees
- Winding
- Unidirectional, wig-wag pinion
- Calendar
- Date at 3, rapid correction
- Seconds
- Indirect centre seconds
- Replaced
- The 55x / 56x automatic family
Models and relatives
- Seamaster of the mid-to-late 1970s — TV-dial, cushion and tonneau cases
- Genève and De Ville automatics of the same period
- siblings: 1010 (date), 1011 (date chronometer), 1021 (day-date chronometer), 1020 and 1022 (17 jewels)
Facts and references
These sources support only the scope recorded beside each link. A source link does not establish that every specification or component has been verified.
- Omega 1010–1022 factory technical guide (1972)
Scope: 4 Hz, family variants, 48-hour minimum and separate wig-wag spring
About the illustration
The interactive drawings are schematics, not factory technical drawings or service procedures. Positions, contacts and grouped assemblies are representative; a complete factory geometry and parts survey remains open.
Recorded specifications can depend on the production revision. Figures without scoped supporting evidence remain claims awaiting independent verification.